Carrier operating and maintanance Instrukcja Operatora Pobierz pdf (Strona 24)

Rev. __________

Date _________

2.6

4. Roll

Raise the roll handle and the deck will slide back. Continue this operation

until the approach plate has contacted the ground.Make sure that the rear

bumper and the approach plate are both in firm contact with the ground

before unloading. There should be an equal weight distribution between

the rear bumper and the end of the deck.

5. Winch

Winch the load off of the deck. Refer to the Winch Operation Manual for

specific winch operation procedures.

5a. Ensure that the winch cable is securely attached to the

load and is taut. Ensure that the winch clutch is fully

engaged (the winch is NOT in free spool mode.)

5b. Remove all equipment used to secure the load to the deck

(excluding the winch cable). Release brakes of the load (if

applicable).

5c. Raise the winch control to power unreel the cable from the

drum, lowering the load from the deck.

5d. Secure the load on the ground Remove the winch cable

from the lod and store the cable.

CAUTION: Never disengage the winch clutch when the winch is

under load.

CAUTION: Always maintain a minimum of 5 wraps of cable on the

winch drum.

CAUTION: Always winch load off of the deck, NEVER drive equip-

ment on the tilted deck.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 43 44

Brak uwag

Carrier operating and maintanance Instrukcja Operatora Strona 24