Carrier operating and maintanance Instrukcja Operatora Strona 19

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
Przeglądanie stron 18
Rev. __________
Date _________
2.1
OPERATION
A. Controls
The operating controls for the Jerr-Dan equipment are conveniently located
on both the driver’s and passenger’s side.
All operators must be trained and understand the contents of the operator’s
manual before operating any controls.
Assure adequate operating clearance and the safety of all personnel be-
fore operating the rollback equipment.
The following controls are provided:
1. Power-take-off (in truck cab)
2. Auxiliary engine throttle control
(in truck cab)
3. Rollback control (first handle in control
station)
4. Tilt control, lower deck (second handle in control station)
5. Winch control, lower deck front winch (third handle in control
station)
6. Winch control, lower deck rear winch (fourth handle in control
station)
7. Tilt control, upper deck (fifth handle in control station)
8. Winch control, upper deck (sixth handle in control station)
9. Tow option/Stabilizer, up/down (seventh handle in control
station)
10. Tow option, in/out (eigth handle in control station)
B. Loading the Deck
1. Position
Park the truck with the rear of the deck approximately 12 feet from the
object to be loaded and in line with that object.
CAUTION: The unit should always be loaded and unloaded on level
and stable ground.
10
9
8
7
6
5
4
3
T
P
O
L
L
O
R
T
L
I
T
H
C
N
I
W
H
C
N
I
W
T
L
I
T
H
C
N
I
W
L
I
B
A
T
S
R
A
B
W
O
T
W
O
T
ASSURE PROPER MAINTENANCE.
OR DEFECTIVE.
DO NOT OPERATE IF DAMAGED
ENGAGING TRANSMISSION.
DISENGAGE PTO BEFORE
UNIFORMLY DISTRIBUTED.
CAPACITY LOADS MUST BE
COMPLY WITH ALL LOAD RATINGS.
ADEQUATELY SECURE ALL LOADS.
TO TOWED VEHICLE.
USE SAFETY CHAINS FROM SUBFRAME
TILT ONLY WHEN DECAL ALIGNS WITH
ASSURE SAFETY OF ALL PERSONNEL.
FIRST CONTROL HANDLE.
ASSURE ENGAGEMENT OF WINCH DRUM.
UNDERSTAND THE OPERATOR'S MANUAL.
ALL OPERATORS SHOULD BE TRAINED AND
OPERATING INSTRUCTIONS
343
12 FT.
1
Przeglądanie stron 18
1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 43 44

Komentarze do niniejszej Instrukcji

Brak uwag