Carrier operating and maintanance Instrukcja Operatora Pobierz pdf (Strona 22)

Rev. __________

Date _________

2.4

7. Roll

Lower the roll control handle to roll the deck forward until the deck is in the

proper position for tilting. The deck is in the proper position for tilting when

the decal pointer is aligned with or just behind the roll (first) control handle.

8. Tilt

Lower the tilt control handle to lower the front of the deck until the deck

lays flat on the slide pads on the hold down.

NOTE: Tilting deck when fully forward will cause damage to the hold

downs.

9. Roll

Lower the roll control handle to roll the deck forward until it is in the full

forward position and under the hold downs.

10. Secure Load

All loads must be secured from movement in all directions using safety tie-

downs. Jerr-Dan provides straps and chains suitable for securing most

vehicles to the deck. Vehicles should be secured at all four corners using

safety tie-downs. Set brakes (if a vehicle) and use wheel blocks and tie-

downs for safe transport. Refer to the AAA or vehicle manufacturers

towing manual for correct attachment points.

CAUTION: Use safety tie-downs to secure the load against rearward

motion. Leave the winch cable attatched to the load and

taut, but do not rely on the winch cable to secure the load.

11. Disconnect PTO

Return the engine to normal idle speed and disengage the PTO before

engaging the transmission. Driving the truck with the PTO engaged will

cause overspeeding. Overspeeding of the PTO and/or pump will greatly

shorten their life and can cause damage to the PTO, pump, and transmis-

sion.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 43 44

Brak uwag

Carrier operating and maintanance Instrukcja Operatora Strona 22