Carrier operating and maintanance Instrukcje Operacyjne Pobierz pdf (Strona 6)

Electrical Voltage

This pictogram indicates that

there are electrical components

behind this access cover, door

or panel that may be dangerous

for the user/installer. Only per-

sonnel qualified in accordance

with EN50110 is permitted to

carry out work on these compo-

nents. The pictogram is attached to the access cover

for the electric heater control box.

Removal of Transport Brackets

This pictogram is located at the bottom of the fan

section. It indicates that the transport brackets must

be removed during commissioning before the fan is

started up.

Central Data

This label contains the data for the AHU, such as

order number, position number etc. If present, the

label is normally located on the access cover or the

door of the fan assembly.

Opening the Fan Door

This pictogram is positioned on the outside of the door

or access cover of the fan assembly. This pictogram

warns that the fan must have been switched off and

deenergised for a minimum of two minutes before

the door or access cover is opened.

Caution: All doors and access covers must be closed

before starting up the AHU.

Unit Matching Label

This label shows that matching surfaces of AHU units

for assembly. It exists at bottom right and left corner of

units. Sample label is as follows.

Lifting and Transport

An instruction is attached to the AHU that describes

the procedures that must be followed for lifting and

transport.The following chapter contains further

details.

1.4. Disposal of Parts/Materials

- The packaging material must be disposed of in a

responsible manner and in accordance with local

regulations.

- Components that are replaced, must be disposed

of as described above.

2. TRANSPORT AND LIFTING INSTRUCTIONS

2.1. General

Transport and lifting of the AHU must always be in

accordance with the instructions below. If these in-

structions are not observed, irreparable damage may

occur to the unit, and people in the immediate vicinity

of the unit are also endangered. Alarko Carrier does

not accept any responsibility if these instructions are

not observed. Transport and lifting must be carried out

by qualified personnel. The AHU must only be lifted

with lifting bars supplied by Alarko Carrier. Lifting must

be carried out in accordance with local regulations

and with the help of certified lifting aids.

2.2. Transport and Storage

Lifting of the AHU is only permitted under the desig-

nated lifting methods. For transporting,

marked

points shall be used. If it is not possible to use

marked points due to the loading conditions, trans-

porting from side profiles can only be done by forklift

(cranes cannot be used). This applies to transport as

well as storage, and is indicated on the side profiles by

warning label.

Electrical voltage

This pictogram indicates that there are electrical components

behind this access cover, door or panel that may be dangerous

for the user/installer. Only personnel qualified in accordance

with NEN 3140 is permitted to carry out work on these

components. The pictogram is attached to the access cover

for the electric heater control box.

Removal of transport brackets

This pictogram is located at the bottom of the fan section. It

indicates that the transport brackets must be removed during

commissioning before the fan is started up.

Verwijder transportbeugels voor opstarten ventilator.

Remove transport brackets before starting up the fan.

Retirer les fixations de transport avant démarrage.

Central data

This label contains the data for the AHU, such as order

number, position number etc. If present, the label is normally

located on the access cover or the door of the fan assembly.

Opening the fan door

This pictogram is positioned on the outside of the door or

access cover of the fan assembly. This pictogram warns that

the fan must have been switched off and deenergised for a

minimum of two minutes before the door or access cover is

opened.

Lifting and transport

An instruction is attached to the AHU that describes the

procedures that must be followed for lifting and transport.

The following chapter contains further details.

1.4 - Disposal of parts/materials

- The packaging material must be disposed of in a responsible

manner and in accordance with local regulations.

- Components that are replaced, must be disposed of as

described above.

2 - TRANSPORT AND LIFTING INSTRUCTIONS

2.1 - General

Transport and lifting of the AHU must always be in

accordance with the instructions below. If these instructions

are not observed, irreparable damage may occur to the unit,

and people in the immediate vicinity of the unit are also

endangered. Alarko Carrier does not accept any

responsibility if these instructions are not observed. Transport

and lifting must be carried out by qualified personnel. The

AHU must only be lifted with lifting bars supplied by

Alarko Carrier. Lifting must be carried out in

accordance with local regulations and with the help of

certified lifting aids.

2.2 - Transport and storage

Lifting of the AHU is only permitted under the designated

lifting points. Lifting under the cross beams is prohibited.

This applies to transport as well as storage, and is indicated

on the cross beam with the following label.

! WARNING!

Before opening doors, switch off and deenergise the

fan, and ensure that it has stopped rotating.

(minimum of 2 minutes)

Caution: All doors and access covers must be closed before

starting up the AHU.

Air Handling Units deliver to the side by sections. Mov-

ing the plastic cover will let the dirt and particulates en-

ter to the unit from openings. Do not move the protection

cover unless you complete the installation of the unit.

1 2 3 4 5 6 7 8 9 10 11 ... 40 41

Komentarze do niniejszej Instrukcji

Brak uwag

Carrier operating and maintanance Instrukcje Operacyjne Strona 6

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Klimatyzatory typu split Carrier operating and maintanance