Carrier operating and maintanance Instrukcje Operacyjne Pobierz pdf (Strona 14)

Figure 27.

roof finish, unit with shorter top section

without intermediate base frame

• A longer top section needs no further finish at the

ends.

Figure 28.

Unit with longer top section without inter-

mediate base frame

NOTE: For outdoor installation seal all jonts

resulting from the mounted profiles. This applies

to both corner and butt joints.

6.2. Unit with Intermediate Base Frame

Figure 29.

Unit with intermediate base frame

Indoor Installation

For indoor installation connection profiles of 240 mm

length are supplied.

• Position the casings on top of one another so that

the corner posts are in the same plane. The base

frame of the top section should be slightly back com-

pared to the bottom casing section.

If stacking units in an indoor installation the connec-

tion profiles should be placed between the different

unit sections. Use the following assembly method:

• Install a connection profile to the end of the casing

section, stopping at the module line (A).

• Install a connection profile at the joint (B).

•Install a connection profile against the adjacent

section (C).

(Equal Width)

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 40 41

Brak uwag

Carrier operating and maintanance Instrukcje Operacyjne Strona 14