Carrier 40CS024 Instrukcja Obsługi Pobierz pdf (Strona 4)

Step 4—Outdoor Unit

1. Make sure to leave sufficient space around the unit. See Fig.

3 for minimum required distances between the unit and nearby

walls. DO NOT BOX IN UNIT.

2. Install the unit in a location with convenient access for service

and maintenance purposes.

3. Position the unit to minimize motor noise which reaches the

customer and neighbors.

4. In heating mode, water can form in the condenser. A drainage

hose may be attached to the unit. Use an adapter as shown in

Fig. 4.

Step 5—Indoor Unit (General)

1. Make sure to leave sufficient space around the unit. See Fig.

6 and Fig. 16 for minimum required distances between the unit

and the ceiling, floor and surrounding walls.

2. Locate the unit to ensure free air flow around it.

3. For greater convenience, place the power disconnect near the

unit on the right side.

4. Avoid installing the unit near a source of heat, such as direct

sunlight, steam or a flame.

5. Install the unit in a location with convenient access to

refrigerant line connections for service and maintenance

purposes.

INSTALLATION

Step 1—Installing the Indoor Unit (Console)

REFRIGERANT LINE ROUTING

The refrigerant lines may be routed in either of the two directions

shown in Fig. 7.

INSTALLING THE MOUNTING BRACKET

1. Carefully remove the air intake grille; remove the two screws

at its sides and pull the grille out with its center retaining

spring, as shown in Fig. 5.

2. Remove the seven screws which appear in Fig. 5 and remove

the front panel.

NOTE: Make sure that the stepper motor and display cables are

disconnected from the electronic control. (See Fig. 13.)

3. Position the mounting bracket on the wall and level.

4. Mark seven (minimum) drilling holes on the wall, as they

appear in Fig. 8.

5. Drill the holes, insert the wall plugs and use the long screws

to attach the mounting bracket to the wall.

6. Check that the bracket is level and securely fastened to the

wall.

7. Hang unit on mounting bracket and mark (2) holes from the

bottom of the unit for the hold down screws.

Table 2—Standard Parts (Under Ceiling)

PART NAME QUANTITY DIAGRAM

Upper and Lower

Mounting Strips

Right and Left

Mounting Strips

Left Side Strip 1

Right Side Strip 1

Anchor Screw

(3/8-in. X 2-in.)

Screw

(UNC 10 X 2-in.)

Nut

(UNC 10)

Metal Screw

(#10–1/2-in.)

Table 3—Maximum Tubing Lengths and Heights

INDOOR UNIT OUTDOOR UNIT

LENGTH HEIGHT

Mtr Ft Mtr Ft

40CG/CS-018 38CG/CS-018 30 98 15 49

40CG/CS-024 38CG/CS-024 40 131 20 66

40CG/CS-030 38CG/CS-030 30 98 10 33

1 2 3 4 5 6 7 8 9 ... 19 20

Komentarze do niniejszej Instrukcji

Brak uwag

Carrier 40CS024 Instrukcja Obsługi Strona 4

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Klimatyzatory typu split Carrier 40CS024