Carrier 558D Instrukcja Użytkownika Pobierz pdf (Strona 11)

851-558 Rev. D 11 Dorner Mfg. Corp.

Fixed and Adjustable Height Stands

Preventive Maintenance and Adjustment

1. Loosen button screws (Figure 22, item 2).

2. Turn kit bolt (Figure 23, item 1) to required height.

Figure 23

3. Tighten button screws (Figure 22, item 2) to 150 in–lb

(17 N–m).

4. Repeat steps 1 through 3 on opposite Adjustment Kit.

Conveyor Angle Adjustment

Required Tools

• 6 mm Hex Key Wrench

1. Loosen flange socket screws (Figure 24, item 1) on

both sides of stand.

Figure 24

2. Adjust conveyor to desired angle.

3. Secure flange socket screws (Figure 24, item 1) to 24

ft-lb (18 Nm).

4. If conveyor is equipped with diagonal bracing (Figure

25, item 1), socket screw (Figure 25, item 2) must be

loosened to adjust conveyor angle. Secure screw to 100

in–lb (11 N–m) after adjustment.

Figure 25

WARNING

Failure to secure screws (Figure 22, item 2)

may cause conveyor sections to drop down

causing severe injury.

TIGHTEN SCREWS (Figure 22, item 2) AFTER

ADJUSTMENT.

WARNING

Loosening stand height or angle adjustment

screws may cause conveyor sections to drop

down, causing severe injury.

SUPPORT CONVEYOR SECTIONS PRIOR TO

LOOSENING STAND HEIGHT OR ANGLE

ADJUSTMENT SCREWS.

NOTE

To rotate stand top plate, screws (Figure

24, item 1) may need to be re-located to

other t–slots (Figure 24, item 2).

WARNING

Failure to secure screws (Figure 24, item 1)

may cause conveyor sections to drop down,

causing severe injury.

TIGHTEN SCREWS (Figure 24, item 1)

AFTER ADJUSTMENT.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Komentarze do niniejszej Instrukcji

Brak uwag

Carrier 558D Instrukcja Użytkownika Strona 11

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Nie Carrier 558D